Multi-Pin Meso Needle Model Matrix

Conceptual illustration of a multipin meso needle attachment and nine-point layout; not an actual product photograph
Editorial illustration. Consult the linked product listing for the supplied product.

Catalog information checked 2 November 2026 · NovaClin Labs

Three multi-pin meso needle combinations are currently listed by NCL. Use the model matrix to keep gauge, pin count and adjustable needle length together. A blank combination is not a listed stock item.

Current NCL multi-pin model matrix
Model Pin count Listed adjustable length Product details
32G multi-pin 9 0–2 mm 32G nine-pin listing
32G multi-pin 16 0–2 mm 32G sixteen-pin listing
34G multi-pin 9 0–2 mm 34G nine-pin listing

Configurations not listed in this matrix

The catalog reviewed does not list three-, four- or five-pin models, or a 34G sixteen-pin model. Contact NCL if your requirement is different; this reference does not establish their availability or suggest that the listed products are substitutes.

Complete the enquiry record

Field Information to provide or request
Requested model Gauge, pin count and exact product reference
Host system Exact syringe or device model and reference
Compatibility Written confirmation for the complete assembly
Adjustment information Current instructions, range definition and any required tolerances
Commercial information Pack quantity, availability and current quotation

What this comparison does not establish

The listed configuration does not prove that attachments fit the same host system or produce the same clinical result. The 0–2 mm range is a catalog specification, not an operating recommendation. Do not infer increments, calibration procedures or a treatment setting from the endpoints.

Keep the supplier’s response with the model record so the receiving team and clinical reviewer refer to the same product. Recheck the record if the proposed host device or attachment changes.

Read the guide for searches involving other pin counts and the 0–2 mm label explainer, or use the compatibility enquiry page.